Forums - Mixing & FX
Subject: ho-hum
Original Message Date: 18-Sep-02 @ 10:15 AM - ho-hum
I've got a rode ntk going through a focusrite trakmaster into the patch bay (behringer) at +4 then out into my terratec ews88mt soundcard, with the input selected at +4. I know valves are a little noisy, and the hum only bothers when i have to crank the gain up but should there be _any_ hum?
There was a huge hum at one point and a horribly thin sound from the mic, but i resoldered the xlr and it was better. Shall i just make up a new lead?
Message 11/25 18-Sep-02 @ 09:01 PM - RE: ho-hum
do you get anything if you only put the cable in 1/2 way??
Message 12/25 19-Sep-02 @ 12:54 PM - RE: ho-hum
The fact that your dynamic doesn't work at all could be a clue. Did you switch off the phantom power before connecting it. Does it work if you plug it straight into the mixer? If you put phantom power on an unbalanced mic you can burn out the coil. Your best bet is to get a new lead.
Message 13/25 19-Sep-02 @ 02:34 PM - RE: ho-hum
wired a new lead with new xlr connectors, beautiful. i really should get a circuit tester.
Message 15/25 19-Sep-02 @ 03:27 PM - RE: ho-hum
Message 16/25 19-Sep-02 @ 03:31 PM - RE: ho-hum
Message 17/25 19-Sep-02 @ 04:54 PM - RE: ho-hum
Does an elephant have a boot in the middle of its face? Does DT place a biscuit on your hard drive?
Do you have a fanny?
Pages: 1 2 3
There are 25 total messages for this topic
Reply to Thread
You need to register/login to use the forum.
Click here to Signup or Login !
[you'll be brought right back to this point after signing up]
Back to Forum