Forums - Mixing & FX
Subject: Yamaha_01V fader motor settings
Viewing all 2 messages - View by pages of 10: 1
Original Message 1/2 26-Aug-03 @ 11:15 AM - Yamaha_01V fader motor settings [Link: Yamaha - 01V]
with the system.
I have been able to solve most but just want some advice on the faders
Motorised control.
Most of the faders seem to work correctly and will go to the prese levels
with the exception of three of them.
I thought it may well be the motors but they all seem to work OK, if I carry
out the calibration set up in the handbook.
I figure they can be turned on and off but the handbook does not tell me how
to carry this out.
Just a little afraid I will upset the rest of the settings.
Please provide some advice how to check this out and rectify the situation.
I think I should be able to compare the defective channels with the three
defective one but not to sure what to look for.
Best regards
Jeff Kinera
Message 2/2 26-Aug-03 @ 02:30 PM - RE: Yamaha_01V fader motor settings
The patch is probably loading OK, since the fader position before you touch anything just indicates where it's set at. The program determines the levels until you actually start to mix.
Is it way off? Causes a noticable/irritable jump in volume?
-Craig
Viewing all 2 messages - View by pages of 10: 1
There are 2 total messages for this topic
Reply to Thread
You need to register/login to use the forum.
Click here to Signup or Login !
[you'll be brought right back to this point after signing up]
Back to Forum